EHC Field Services is your complete source for Ultra High Velocity Turbine Generator Lube Oil, EHC and Ancillary System Flushing, Fluid Remediation Services and Rentals. Located in the Carolina, Puerto Rico Metro Perimeter, EHC has a distinct advantage in faster, lower cost mobilization, both by sea, air and land, to customer locations anywhere in Caribbean, Central and South America Region. The Atlanta, Georgia International Airport is minutes away from our location, for expedited Technical Management travel as well as for large or small air freight of our Equipment anywhere in the world. ULTRA HIGH VELOCITY LUBE OIL AND EHC FLUSHING SERVICES AND EQUIPMENT FOR: GE EHC AND MHC STEAM TURBINES GE EHC AND MHC GAS TURBINES GE COMBINED CYCLE STEAM TURBINES GE INDUSTRIAL EHC AND MHC STEAM TURBINES WESTINGHOUSE/SIEMENS EHC AND MHC STEAM TURBINES SIEMENS/WESTINGHOUSE EHC AND MHC GAS TURBINES MITSUBISHI/WESTINGHOUSE EHC AND MHC COMBINED CYCLE STEAM TURBINES SIEMENS/WESTINGHOUSE INDUSTRIAL EHC AND MHC STEAM TURBINES ALSTOM/BBC EHC AND MHC STEAM TURBINES ALSTOM EHC AND MHC GAS TURBINES ALSTOM COMBINED CYCLE EHC AND MHC STEAM TURBINES ALSTOM INDUSTRIAL EHC AND MHC STEAM TURBINES ELLIOTT STEAM TURBINES DRESSER RAND STEAM TURBINES PRATT & WHITNEY GAS TURBINES WARTSILA DIESEL IC GENSETS SOLAR TURBINES (INCLUDING AIR COOLED OIL COOLERS) TOSHIBA STEAM TURBINES
EHC Field Services designs and manufactures the Equipment utilized in its' Flushing Systems and the result is superior to those who do not use purpose built equipment. We produce a cleaner system; faster than anyone else in the industry.	EHC Field Services has extensive experience in the Ultra High Velocity Flushing and Remediation of Lube Oil and Electro Hydraulic Control Oil (EHC) Fluid and Systems  Our 45 years of Flushing and Remediation experience qualifies EHC for Services and Rentals in the areas of maintenance and commissioning
EHC UHV Ancillary Flushing System This UHV Ancillary Flushing System is "surgically clean" and enables EHC to provide Ultra High Velocity Flow to Lube, Hydraulic and Control Oil Systems that possess a Reservoir that is too small to accomodate our larger UHV Turbine-Generator Flushing Systems and requires very little temporary modification to the permanent Reservoir. The result is a cleaner system than conventional low velocity or chemical flushes using the permanent system pump equipment. The Ultra High Flow Rate along with submicronic filtration at strategic points in the loop results in a superior mechanically cleaned System. Upon completion of the Ultra High Velocity Flushing Procedure, the conveyance piping system and the fluid in the Reservoir is remediated to a cleaner level than the acceptable level by OEM published specifications for particle count in a 100 ml sample. Ancillary Systems include: Boiler Feed Pump Turbines Lube Oil Storage and Transfer Systems FD and ID Fan Lube Systems Pulverizer Lube Systems Hydraulic Systems Control Oil Systems Generator H2 Seal Oil Systems Air Cooled Lube Oil Cooler Systems Any Lube or Hydraulic Systems from 1" to 12" Inside Diameter Large Reservoir High Volume Filtration Recirculation	Our Equipment is Shipped in Conex Containers to your site, always micronically clean and ready to work! EHC LAB TECH AT WORK Electronic Particle Count Analysis is performed on site for trending purposes to evaluate the condition of the Lube and/or Control Oil System before, during and after the UHV Flushing Procedure using the Portable Oil Diagnostic System.The results of this analysis is converted to NAS and ISO equivalent values for the convenience of the client. Our Proposals outline the target cleanliness level for each system and is normally exceeded by our services. Whenever possible, EHC recommends to the client that final particle count analysis be performed by a "third party" clean room laboratory for proof of the system cleanliness.